Ic 7600 service manual manual#
Ic 7600 service manual upgrade#

(RCA 50 impedance) Temperature range : 0C to +50C (+32F to +122F) Frequency stability : Less than 0.5 ppm 5 min. of memory channels : 101 (99 regular, 2 scan edges) Antenna connector type : SO-239 2 and phono jack Mode : USB, LSB, CW, RTTY, PSK,ДЄM, FM No. *1Some frequency bands are not guaranteed. General Frequency coverage : (unit: MHz) Receive 0.03060.000*1*2 VR-A, VR-B, VR-C, MIC, JACK and RIT BOARDS). 4-1Д¤-2 REFERENCE FREQUENCY SIGNAL LEVEL ADJUSTMENT. SECTION 4 ADJUSTMENT PROCEDURES 4-1 PREPARATION. SECTION 3 CIRCUIT DESCRIPITON 3-1 RECEIVER CIRCUITS.

READ the instructions of test equipment throughly before connecting a test equipment to the transceiver. The transceiver and a Deviation Meter or Spectrum Analyzer when using such test equipment.ДЁ. ALWAYS connect a 50 dB to 60 dB attenuator between DO NOT transmit power into a Standard Signal DO NOT keep power ON for a long time when the Insulated tuning tool MUST be used for all adjustments.5. DO NOT short any circuits or electronic parts. DO NOT force any of the variable components. DO NOT open the transceiver until the transceiver isДisconnected from its power source.3. Make sure that the problem is internal beforeДisassembling the transceiver.2.

and ICOM logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the United Kingdom, Germany, France, Spain, Russia and/or other countries. Quantity requiredДЎ130013010 SN74AHC1G08DCK3 IC-7600 LOGIC UNIT 1 pieceДЁ930079060 3073 DC PLATE IC-7600 CHASSIS 2 piecesДЄddresses are provided on the inside back cover for your convenience.

Ic 7600 service manual upgrade#

To upgrade quality, any electrical or mechanical parts and internal circuits are subject to change without notice or obligation.Д«e sure to include the following four points when ordering replacement parts:ДЎ. This could damage the transceivers front-end.

This will ruin the transceiver.ДO NOT expose the transceiver to rain, snow or any liquids.ДO NOT reverse the polarities of the power supply when connecting the transceiver.ДO NOT apply an RF signal of more than 20 dBm (100 mW) to the antenna connector. NEVER connect the transceiver to an AC outlet or to a DC power supply that uses more than specified.

Ic 7600 service manual manual#

This service manual describes the latest technical information for the IC-7600 HF/50 MHz TRANSCEIVER TRANSCEIVER at the time of publication. HF/50 MHz TRANSCEIVERGuest.notebookDownloaded